The short answer

By Ricky Hudson, owner, Acts of Service Plumbing.
Flush a tankless water heater once a year. "That's an annual service," Ricky says. "They recommend doing that every year unless they've got a whole-house water filtration system on it." Tulsa water is hard, and those minerals turn into scale inside the heat exchanger, the part that heats your water. Our annual service is $225. It's more than a flush: "That also includes checking all the fittings, checking the venting, making sure there's no issues with it."
Why Tulsa tankless units need a yearly flush
A tank water heater stores hot water. A tankless unit heats the water as it moves through a heat exchanger, a set of narrow passages that get very hot every time you open a hot tap. Those passages are where the minerals in your water drop out and stick.
Oklahoma water is hard. According to the City of Tulsa, the water averages 8.2 grains per gallon from the A.B. Jewell plant and 5.2 grains per gallon from the Mohawk plant. On a tank heater, that same hardness settles to the bottom as sediment, which is the popping noise some tanks make (see Why Is My Water Heater Popping?). On a tankless unit, it coats the heat exchanger instead.
As scale builds up, the unit has to work harder to get the same heat into the water. Hot water can come slower or not as hot. The unit can overheat and shut itself down with an error code. The flush dissolves that scale and rinses it out before it does damage.
The warranty cares about it too
This is the part many homeowners don't know: the manufacturer's warranty calls for a licensed plumber to flush the heat exchanger once a year. On Navien units, the manufacturer covers the heat exchanger for 15 years and internal parts for five. Every tankless install we do also comes with our own two-year parts-and-labor warranty.
Keeping a record of yearly service by a licensed plumber protects the most expensive part of the unit. That's one reason we don't publish a do-it-yourself flush here. Our office system sends you a reminder when your one-year flush is due, so you don't have to remember.
How long a tankless unit lasts with (and without) the flush
With a yearly flush, a tankless unit with a stainless steel heat exchanger can last 25 years or more. One with a copper heat exchanger typically lasts 15 to 20 years. A standard tank lasts about 10 to 15. Those numbers are what we typically see, not a guarantee, and they assume the unit is maintained. Skip the flush year after year in Tulsa water and the heat exchanger carries the scale load the whole time.
What our annual tankless service includes
Ricky's description from the call: the flush, plus "checking all the fittings, checking the venting, making sure there's no issues with it." Here's what that looks like on our job records:
- Descale the heat exchanger. We run a tankless descaling solution through the unit to dissolve mineral buildup.
- Flush out the solution. After the descale, we rinse the remaining solution out of the unit.
- Check the filters. Our crews check all three filters on the unit. On our Sapulpa visit, the fresh-air filter and water filter were clean. On our Bixby visit, we cleaned and checked them.
- Check every fitting. We look for drips and loose or corroded connections on the water lines, the gas line and the condensate drain.
- Check the venting. We make sure the exhaust and intake are clear and connected.
- Check the house water pressure when there's a reason to. On a Bixby service, Casey and Jared found the house pressure over 100 psi, which is hard on a tankless unit and every fixture in the house.
Tell us before the visit about anything you've noticed, like a fixture that runs hot and cold, a code on the display or a drip. Then we can look at it on the same trip.
Signs your tankless unit is overdue
- Hot water takes longer to arrive, or isn't as hot as it used to be.
- The temperature swings while you're using it.
- An error code shows on the front panel. On Navien units, E016 (heat exchanger overheating) and E030 (exhaust overheating) often point to scale or a clogged cold-water inlet filter. See Navien Error Codes Explained.
- Water or moisture around the unit or its condensate line.
- You can't remember the last time it was serviced, or you bought a home with a tankless unit and no service records.
None of these on its own proves the unit needs a flush. A shower that changes temperature at one fixture only may be a separate problem. Our Sapulpa job story says so plainly. If more than one fixture is affected, tell us.
What the yearly service catches
Slow hot water in Bixby. A Bixby homeowner noticed the hot water wasn't getting hot as fast, or as hot, as it used to, and worried the recirculating pump had failed. Casey and Jared did the annual service and descaled the heat exchanger. They also tested the house pressure and found it over 100 psi with a pressure-reducing valve starting to fail, so we replaced the PRV the same day. Read the Bixby tankless and PRV job story.
A leak found during maintenance in Broken Arrow. Travis went out for a yearly service, and the homeowner had also noticed a leak. It was the condensate line connection, a brass fitting on PEX. He ran a short length of 3/4-inch PEX straight to the drain and finished the service. Read the Broken Arrow job story.
A straight flush in Sapulpa. We descaled the unit, flushed out the solution and checked all three filters. We were also honest that the flush didn't confirm a fix for one upstairs shower's temperature swings. Read the Sapulpa flush job story.
Two jobs on one visit in Claremore. We descaled the tankless heat exchanger, checked fittings and filters, and reset a rocking toilet on the same trip. Read the Claremore job story.
Does whole-house filtration change the schedule?
It can. Ricky's yearly recommendation comes with an exception: homes with a whole-house water filtration system. Treating the water before it reaches the heater means less mineral going through the heat exchanger. During a visit we'll look at your filtration setup and your unit, then recommend the schedule that fits your home. Your manufacturer's warranty terms still apply, so ask us what your unit's paperwork requires. See our whole-home filtration install in Broken Arrow and our water filtration service.
What you can safely do between services
- Look at the unit once in a while for drips at the fittings and the condensate line.
- Keep the outdoor exhaust and intake pipes clear of leaves, snow and nests.
- If a code shows up, write it down exactly and press the reset button once. If it comes back, call us.
- If you smell gas, don't reset anything. Leave the house and call the gas company from outside.
Leave the descale to a licensed plumber. It involves chemicals, isolation valves and a gas appliance, and the warranty calls for a licensed plumber.
Thinking about going tankless?
If you're still on a tank and the yearly upkeep is part of your decision: Navien tankless installations start at $5,999 for parts and labor. Customers with a condensing gas unit typically see the water-heating part of their gas bill drop by about half. Oklahoma Natural Gas offers rebates of up to $1,100 on a qualifying unit. See Tankless Water Heaters, How to Claim Your ONG Tankless Rebate and Replacing a Water Heater in Tulsa.
When the flush isn't the whole answer
A flush clears scale. It doesn't replace a failed part. If the unit still throws a code after service, or a sensor, fan or limit control has failed, the next step is testing. Michael explains how we handle parts: "We'll call tech support, 'cause a lot of times the water heater's under warranty." We work with "AO Smith on water heaters, Navien on tankless units," and "a lot of times the parts will be under warranty, so then that's free for the customer."
You also get a straight answer on repair versus replacement. "If your water heater can be repaired or needs to be replaced, the technician gets paid the same." Our techs are paid hourly, not on commission, and you get a flat-rate price before any work starts. A service call starts at $89 and is waived when you approve the repair. See Water Heater Repair, or No Hot Water? Quick Checks if the water quits completely.
Some hot-water complaints come from other parts of the system, like the recirculating pump or its controls. In Glenpool we added an aquastat to an existing recirculating pump and tested it. Read the Glenpool job story.
When to call us
- Book your yearly service if it's been about a year since the last flush (or you don't know), or hot water is slower or cooler than it used to be.
- Call sooner if an error code comes back after one reset, you see water around the unit or condensate line, or the unit shuts down and won't restart.
- Call the gas company from outside if you smell gas.
Book your annual tankless service
Book online or give us a call. We're a licensed, family-owned plumber in Tulsa (Oklahoma license #035596) serving Tulsa, Bixby, Broken Arrow and the surrounding area with flat-rate, upfront pricing. See Tankless Water Heaters or schedule service.
Page last updated November 2026.
Straight Answers
How often should I flush a tankless water heater in Tulsa?
Once a year. Tulsa water is hard, and the minerals build up as scale in the heat exchanger. Homes with whole-house water filtration may be on a different schedule.
How much does a tankless water heater flush cost?
Our annual tankless service is $225. That includes the flush plus checking the fittings, venting and filters.
What is included in a tankless water heater flush?
We descale the heat exchanger, flush out the solution, check the filters, check every fitting and check the venting.
Does the Navien warranty require a yearly flush?
The manufacturer's warranty calls for a licensed plumber to flush the heat exchanger once a year. Navien covers the heat exchanger for 15 years and internal parts for five.
What happens if I never flush my tankless water heater?
Scale builds up in the heat exchanger. Hot water can get slower or cooler, and the unit can overheat and show codes like E016 or E030.
Can I flush my tankless water heater myself?
We suggest leaving it to a licensed plumber. The manufacturer's warranty calls for a licensed plumber to do the flush.
Do I need a flush if I have whole-house water filtration?
Filtration reduces the minerals reaching the heater, which can change the schedule. Ask us what your unit and warranty call for.

