On the job in Tulsa




At a glance
- Where: Tulsa, OK 74133
- Completed: November 9, 2026
- Services: Gas line repair · Emergency plumbing
- Licensed: Oklahoma plumbing license #035596
What the homeowner was dealing with
This one came in as an emergency. The homeowner in Tulsa ZIP 74133 had called Oklahoma Natural Gas, and ONG found a leak by the kitchen cooktop. As they do when they find a leak, ONG turned the gas off to the house and required an inspection before it could be turned back on. That left the house with no heat, no hot water and no stove.
When the homeowner called us, our office gave them only the service charge over the phone. A gas leak job does not have a set price, and the process (finding leaks, pressure testing, permit, inspection) is better explained in person by the tech than guessed at on the phone.
Six appliances on one system
Casey and Jared started by taking stock of what the gas system fed, because every branch has to hold pressure to pass. This house had six gas appliances and outlets: two furnaces in the attic, a fireplace, a water heater in the garage, the kitchen gas range and a gas line next to the AC units.
They put the system under 3 pounds of pressure from the meter. The plan, written into the estimate, is to check for immediate leaks and repair them during the first hour, then come back the next day to make sure the pressure is still holding.
The leak ONG reported was under the kitchen island. To get to it, the crew had to cut a small piece out of the cabinet to expose where the gas line goes down into the slab. That line is sleeved in PVC where it enters the concrete. The leak was on the main line feeding into the house at that point, at the fittings.
Resealing the fittings and testing
The crew took the leaking fittings apart, cleaned the threads, and put them back together with Teflon tape and pipe dope before re-securing them. Then they aired the system back up to 3 pounds and let it sit for 20 minutes. The gauge held.
Holding for 20 minutes is good. It is not the end. A slow leak can take hours to show on a gauge, which is why the process includes coming back the next morning to read it again before the inspector arrives.
Gas work in Tulsa needs a permit. We pulled the City of Tulsa residential gas permit and scheduled the inspection for the following morning, November 10. Handling the paperwork and the inspection is part of the job, so the homeowner did not have to deal with the city directly.
Why ONG will not just turn it back on
Homeowners are sometimes surprised that the gas company will not simply relight everything after a leak is fixed. The rule protects you. Once ONG has found a leak and shut the gas off, they want proof from a licensed plumber and a city inspector that the whole system is tight. A pressure test on every branch is how a plumber proves that.
It is also why the test covers all six appliances, not just the cooktop. The test pressure goes through the whole system, so a second leak at an attic furnace or behind the fireplace would show up on the same gauge.
Leak repaired, system holding, inspection set
By the end of November 9, the leak under the kitchen island had been repaired, the system was holding 3 pounds on the gauge, the permit was pulled and the inspection was on the calendar for the next morning, with a return visit to read the gauge again. The small opening in the cabinet was what it took to reach the line.
We applied a customer discount on this job. Once the system passes inspection, ONG can restore service.
How a gas pressure test works
A gas pressure test is simple in principle. The tech isolates the house piping from the meter, connects a gauge and pumps the system up to a test pressure, here 3 pounds. That is far above the pressure your appliances normally see. Then everyone waits. If the needle drops, gas would be escaping somewhere.
To find where, the crew works through the system: appliance connections, valves, unions and any spot where pipe enters a wall or slab. Leak detector solution bubbles at a leaking joint. In this house the spot ONG had flagged near the cooktop led the crew to the island, where the line drops into the slab inside a PVC sleeve.
The test is also why a gas leak job has no single set price. A system with one leak and a system with five take very different amounts of time. Our office quotes the service call over the phone and the tech explains the rest in person, once they can see the system.
What this means for your home
If you smell gas, leave the house first, then call the gas company from outside. If they find a leak and shut you off, you will need a licensed plumber to find and fix the leak, pressure test the system and get it inspected before service comes back.
Ask your plumber how long the gauge has to hold, whether they will come back to check it, and who is pulling the permit. See gas line repair in Tulsa for what the process looks like.
Services on this job: Gas line repair · Emergency plumbing · Plumber in Tulsa · How our pricing works · All job stories
Straight Answers
How do you get the gas turned back on after ONG shuts it off for a leak?
A licensed plumber has to find and fix the leak, pressure test the system and pass a city inspection. In this Tulsa home we repaired the leak under the kitchen island, held 3 psi on the gauge and scheduled the City of Tulsa inspection for the next morning.

